Ron Pope Motorsports                California Custom Roadsters               

Wilwood remote master cylinder

Jim B

Active Member
Is there any reason that this master cylinder could not be installed on it's side, rotated 45 degrees to lay flat? The reservoir will be remote about 2 feet away. Thanks.
remote master.jpg
 
How about installing it on it's side with the tube ports facing up so the bleeding will be easier?
 
If it were mine, and I had to run it sideways, . .

I'd orient the reservoir feed tubes so they face up with the cylinder in planned position, and then use a pressurized reservoir to bleed it while upside down to eliminate any chance of an air bubble in the plastic reservoir adapters.

The slightest bubble, with the help of inertial forces. could end up in the cylinder.
 
Good plan. Also, maybe bleed it in the normal position and when it is completely air free and rocking, rotate it to the flat position?
 
Why not call Wilwood and see what they have to say, it is their master cylinder. I'm
only guessing, but I bet they have been there, done that.
 
Why not call Wilwood and see what they have to say, it is their master cylinder. I'm
only guessing, but I bet they have been there, done that.


I'd be interested to hear what they have to say on it for sure.

No doubt they have been there - done that . . . . but in this litigious age, a lot of times they can't say anything, (except don't do it) about non-standard uses/mounting positions based on liability concerns.
 
I have the same master cyl without remote res. standing straight up no problem ---the remote would be even easier .
 

Attachments

  • 30124.jpg
    30124.jpg
    406.7 KB · Views: 31
  • P4030136a1.jpg
    P4030136a1.jpg
    586.1 KB · Views: 31

     Ron Pope Motorsports                Advertise with Us!     
Back
Top