Search results
-
-
GPS speedo
Where did you mount your antenna? Is it in the bed under your cover or under your dash? Does it need to be mounted in the open? -
Windshield support rods
Wondering what everyone is using for windshield support rods? SS tubing or solid rod or what? Pictures would be helpful too! -
frame painting
How do you guys mount your frame when painting it? I'm about to paint mine, but can't figure out how to mount it so I have all sides and top and bottom clear for priming and painting. Any ideas, suggestions …. pictures of what you did?- akzale
- Thread
- Replies: 1
- Forum: Frames and Chassis
-
Brake light wiring
Thanks again for the feedback! Y'all are the best! Hey Fart, I went to You Tube and found a video from Ididit talking about the wiring in their column. Just what I needed! I wired it as they said, and it worked just great! The wire feed from the fuse block is the hot wire to the brake pressure... -
Brake light wiring
I have an aftermarket wiring harness, and there is a wire from the fuse block that goes to the brake switch. This wire provides power to the pressure switch I have in the brake line. I also have an Ididit steering column with a wire harness. One of the wires in it is labeled for the brake... -
volt meter connections
Thanks for all the input. Lots of smart folks who took the time to reply with suggestions and offer encouragement. I had another local rodder come to my rescue. He twisted up the wires and everything is cool! My problem was kinda embarrassing as I was wiring up the system as though I had an... -
-
volt meter connections
Tried to post a few pics, but couldn't upload them. I'm going to try running a wire from the battery terminal on the alternator to the "S" (sender) terminal on the gauge. I'll use a switched 12V terminal from the ignition switch to the gauge (and back to the starter) I'll let you know how it... -
volt meter connections
It's an aftermarket brand that I bought online. Maybe that's the problem!! -
volt meter connections
Running wires for my gauges, and I'm stuck on the volt meter. Back of the gauge has 4 terminals. One for a ground, one for the illumination,(from light switch) one for a battery or 12v supply,(from battery terminal on ignition switch) and one from the "sending unit". Can't seem to get the wiring... -
Member from Alaska
Hey Butch27, I'll take a few minutes to look at what pics I can find. If you would like, we can talk and discuss the issues I had and what I would do the next time. My number is 907-982-4186. I'm in Alaska, 4 hours earlier than you. -
Member from Alaska
Butch27 ..... I may be the guy you're looking for! I did post a video showing what I did. Used an original T hinge, and oak reinforcement. Mini bear claw latch that I inset into the door frame. -
reinforcing firewall?
I have an RPM body and didn't notice this issue! I sanded down the inside of the firewall, and glassed in a straight piece of 1/2" marine grade plywood. Set about 50 pounds of weight on it and let it set up for a couple days. The front of the firewall is as straight as can be! I'm well pleased...
