Hi
im building a t bucket ,and going to install an inline chevy 6,230,
does anyone know of anybody that makes motor mounts for that installation
i have neither the proper tools ,or suck to make them myself
I.M.O. the front is extremely high. I would try lowering the front so the balancer is between the frame rails and lowering the rear trans about an inch or two. Relocating mtr. mounts would have to be done. As long as you have ground clearance for the oil pans, say 6"+ get that engine as low as possible. Only my thoughts .
Thank you for visiting the T-Bucket Forums! This site was created in 2006, to provide enthusiasts with a place to discuss T-Buckets. Over the years, there have been many imitators, but this is the T-Bucket resource you have been looking to find. We encourage you to register a FREE account and join in on the discussions.