Hiding wires

[T-Bucket Bob]

Hey guys,

When you put your wiring underneath your seat riser, where do you route your wires to each component?

Thanks, T- Bucket Bob

 

[PotvinGuy]

Some go through the frame rails (to the lights and engine) and some go under the car.

 

[Neshkoro]

As someone said in another post, keep it off the bottom of the frame rails. If it's on the bottom you can't jack up the car without pinching the wires.
Same goes for the brake lines.

 

[Jhexide]

i used the Painless Powerbraid ,that wraps around itself ,and used adel clamps on side of frame

 

[Gary49]

i used the Painless Powerbraid ,that wraps around itself ,and used adel clamps on side of frame

I used the painless brand too at first but found out Summit sells the same thing under their brand for a lot less money. I bought some and couldn't tell the difference.
Gary

 

[Gerry]

Brake line, wiring to the front end all go through the frame rail. Pain in the ass and you can't visually inspect them, but 'clean is clean'