Steering arms

[tfeverfred]

Resinator, could you please post a pic of your custom bolt on steering arms? And do they work with gennie '28-'48 Ford round back spindles? Also, what's the measurement from the center of the mounting bolts to where the tie rod bolt holes are?

 

[RESINATOR]

The steering arms fit the early Ford (1937-1941) round and (1942-1948) square spindles. The dimension from the center of the kingpin to the center of the tie rod is about 5-3/8", I would have to measure a set to get the exact dimension for you. The tie rod and drag link holes are 5/8" and the spindle mount holes are 1/2".
We do sell these as pieces and without the bends for the people doing something different or Chevy patterns.

 

[RESINATOR]

Here's a picture installed, it's older with the Magnum spindle zerk notches.

 

[tfeverfred]

Thank you sooooo, much. I was looking to have the arms behind my axle. Hey, I didn't paint those dang holes in my axle to hide 'em. It'll be a close fit, but they'll work.

Thanks again.

 

[tfeverfred]

Damn, I measured and the won't fit.;( They're about 1/2" too long.