Search results
-
Lisle 33260 Double Flare Tool
The m/c 1/4" port fed a combination valve/ distribution block , that switched to 2- 3/16" lines , one for each front wheel . A single 3/16" line fed the same combo valve & sent 1 -3/16" line to the rear brakes . -
-
Restoring A T bucket that sat 10 + years
^^^^^ Ideas it on the internet , it must be true !!!!..^^^^^^^^- 2old2fast
- Post #88
- Forum: Project Plans & Updates
-
Don't pay the ransom . . . . I've escaped !
Spell check / word predictor sucks !!!!!. The word was DOUBT -
Don't pay the ransom . . . . I've escaped !
Dont worry , I court that will happen ! -
-
1923 T -Bucket Assembly Manual
In 96 that catalog was $25 IIRC....maybe that was the catalog and the assy manual ??- 2old2fast
- Post #20
- Forum: Frames and Chassis
-
-
The Bucket List
Some day in the not so far future , I'll cease to exist , and nobody will give 2 shits about my car ....- 2old2fast
- Post #327
- Forum: Project Plans & Updates
-
27 T something
Whatever is closest to the ground is the only thing that matters , 6" is pretty close ,5" is about minimum if you're gonna drive it. ...- 2old2fast
- Post #19
- Forum: Project Plans & Updates
-
My ProjecTee
Another ,complete,crown automotive wiper motor kit ,$122 complete with motor- 2old2fast
- Post #253
- Forum: Project Plans & Updates
-
My ProjecTee
If you don't like the cable setup , search ; '50 Chevy wiper transmission , solid links and really simple mount , $50 at advanced auto ...( dorman ).......- 2old2fast
- Post #252
- Forum: Project Plans & Updates
-
My ProjecTee
Google 56 Chevy wiper transmission , stems would be easy to mount in the cowl , small on the inside..just something to look at .....probably could get along with 1 wiper ....- 2old2fast
- Post #248
- Forum: Project Plans & Updates
-
My ProjecTee
You'll probably have to extend those shafts ......- 2old2fast
- Post #244
- Forum: Project Plans & Updates
-
My ProjecTee
I'm guessing he's going to French the cowl so just the shaft/stem protrude . they're easily sealed like any other car used to be( before hidden wipers ).... Just a WAG....- 2old2fast
- Post #243
- Forum: Project Plans & Updates
-
-
The Bucket List
I'm no ford expert , but on chevies , the bearing goes below the axle , the sims & bronze washer go above . The weight of the car on the bearing.........the bronze washer against the axle , grease grooves up- 2old2fast
- Post #314
- Forum: Project Plans & Updates
-
Spring nut check . . .
Only cost you a couple hours and a pair of grease seals and some grease to find out whether or not there's a problem .....- 2old2fast
- Post #5
- Forum: Suspension
-
Cooling secrets
Potvin guy , are you talking about a surge tank ? The only time coolant flows into a return tank is when system pressure exceeds cap rating (overly high temperature ), then flows back to the rad. when cool via system vacuum ..- 2old2fast
- Post #17
- Forum: T-Bucket Engine and Driveline Articles
-
Loud exhuast
What temp do you want your engine to operate , 195°-215° is fine for engine wear and efficiency.....- 2old2fast
- Post #113
- Forum: Engines and Drivelines
