Stud Spacing Tool---Homemade

[Don'tCallMeJimmie]

GAB, could you give me the dimensions for 5" to 4 3/4. Thanks, I know it's been a while, but all the rest work GREAT. Thanks,Bruce

Post #12 there, amigo...

Backwards - never mind!

 

[T-Test]

I get bass akwards evey day!!

 

[T-Test]

Reposting this to George Barnes

GAB, could you give me the dimensions for 5" to 4 3/4. Thanks, I know it's been a while, but all the rest work GREAT. Thanks,Bruce​

 

[Mike]

I just checked and George was viewing this thread a few minutes ago. I imagine you'll be getting an answer from him afore long.

 

[GAB]

Sorry about that. I checked this site about 8:45 and saw the post requesting some info. I went to look and see if I had what was wanted and got over on the other computer that I have the CAD stuff on. I have both computers hooked together so that I can us one keyboard, mouse and monitor. While over there the phone rang and I got side tracked and forgot what I was doing. So I wasn't over here as it appeared in the online viewers. Didn't notice until after lunch that I was still active on this site. Again, sorry!

I still haven't found what is being requested. I'll check later and see if I have it or if not, I'll draw it up.

 

[GAB]

Try this:

That one is for going from the existing 5" bolt pattern to the new 4-3/4".

This one is for the reverse, 4-3/4" existing to 5" new.

 

[T-Test]

Thanks, GAB. The others work great!!

 

[Dirt-T]

Great stuff thank you.
Terry

 

[Shea Jones]

would it be possible to get the measurements to make one of these to go from a 5 on 4 mopar small pattern to a 5 on 4 1/2 large mopar pattern. thanks in advance