Garage Merch                Ron Pope Motorsports                California Custom Roadsters               

images needed

odie

Member
i need some images of rear roll pans for 26-27 roadsters. i have afew ideals of my own but would like to see some others.
 
I don't have great shots of my roll pan, but here you go. It is fiberglass and was made by the manufacturer of my body, Poliform. It is about 4-1/2" deep and covers up my gas tank. To mount it, I glassed in pvc tubes through the pan to the flange that sits flush with the body flange. I used fender type body clips on the body flange. I just use a long allen wrench to run some cap screws through to tighten.


DSCN0185.jpg
 
That is a sweetest setup that I've seen on a '26-'27. Most excellent Ben!

Jim
 
It is a chrysler but basically the same idea

0910sr_06_z+1927_chrysler_roadster+rear_end.jpg
 
I don't have great shots of my roll pan, but here you go. It is fiberglass and was made by the manufacturer of my body, Poliform. It is about 4-1/2" deep and covers up my gas tank. To mount it, I glassed in pvc tubes through the pan to the flange that sits flush with the body flange. I used fender type body clips on the body flange. I just use a long allen wrench to run some cap screws through to tighten.


DSCN0185.jpg
That is one nice looking ride. Great job...
 
thanks fellas. i'm sorry i haven't been around to thank yall. i have been having computer problems.
 

     Ron Pope Motorsports                Advertise with Us!     
Back
Top