Shipping from Kodak, TN (RPM)

[askiles]

Okay, so I just had a custom 23 chassis and body built for my by RPM, and I am now looking for a company to ship it for me from Kodak, TN to Phoenix, AZ. It needs to be a company that does not mind if the chassis and body are palletized or crated. Does anyone know of any good companies to use? Please let me know...I want my T!!!! Oh, pic of body on chassis below... Thanks!

-Andy
andyski1es@yahoo.com

 

[putz]

Try Uship.com they are a great site Ron has an account with them. I shipped my bucket to him using it.

 

[RPM]

Try Uship.com they are a great site Ron has an account with them. I shipped my bucket to him using it.

That is who we are trying use Jim. We have had great luck with them. Andy set one up and it turned out to just be a broker for Yellow Freight. They wanted all enclosed on a skid, so they couldn't run a lift truck trough it. We will find one here in the next day or so.

 

[lincolnuT]

Dam shame we didn't know about this load on the way back from Dayton, one more bucket could have made it to at least Artesia NM,,,,,,,,,,,,,,,,,

We know how to deliver parts across the USA right Ron?

Mike
opcorn:

 

[RPM]

Dam shame we didn't know about this load on the way back from Dayton, one more bucket could have made it to at least Artesia NM,,,,,,,,,,,,,,,,,

We know how to deliver parts across the USA right Ron?

Mike
opcorn:

Yes it was not any where near done then. But yes did haul one back to Texas.

 

[askiles]

Anyone else know of any other place to look besides uShip.com??? I would like to throw as many lines out there as possible... Eager to get it...yes! LOL

-Andy

 

[blownt]

you should get plenty of replies from Uship. I got over 20 replies back when I wanted to get a jet boat from CA to Houston Tx. And again when I had a 460 short block shipped from CA to Houston.

 

[askiles]

Hopefully...so far 1 bid that was not correct.

-Andy

 

[oino]

http://www.rlcarriers.com

 

[askiles]

Booked an auto carrier for fairly cheap...we will see if that works out. Fingers crossed.

-Andy

 

[askiles]

Change of plans...Ron is da man and got a GREAT hit on his listing on uShip. Can't beat that! Thanks Ron.

-Andy

 

[sstock]

Okay, so I just had a custom 23 chassis and body built for my by RPM, and I am now looking for a company to ship it for me from Kodak, TN to Phoenix, AZ. It needs to be a company that does not mind if the chassis and body are palletized or crated. Does anyone know of any good companies to use? Please let me know...I want my T!!!! Oh, pic of body on chassis below... Thanks!

-Andy
andyski1es@yahoo.com

That bucket is going to be slammed.

 

[RPM]

That bucket is going to be slammed.

Good eye there Steve. This bucket will be just 4" off the ground. The frame is the lowest point of the car. The oil and tranny pans are 1" up inside the bottom of the frame rails.

 

[T-Odd]

That appears to be about the same setup as what Stitch was running for years - he had small feet, so it wasn't a problem with the gas and brake pedals.

Ron, tell us about the kickup in the back. I like the look of Speedway's new low bucket, just not sure I'd fit in it without a shoehorn.