So like a DA i purchased a finned cover for my S10 rearend and OH crap she no fittie.
could not send it back so here is my solution.18.00 and 2 hours. I had an endmill i used to move the 4 holes in the cover it wont clog like a burr will. I used an old gasket to move the holes at 1-5-7-11. They had to be moved diag tward the center about 1/8
. The other non used holes i just somply ran a 3/8 tap through them I cut the 3/8 Fo bolts off a 1.700 This is the Fo accorn nut installed to simulate a fastener from the out side Now you can see at 1-5-7-11 i have replaced the 5/16 bolt with a stud and a nut 1.900 long Right over the existing cover and it didnt cost 250.00 The 4- 5/16 accorn nuts are not even noticable with the 3/8
Thank you for visiting the T-Bucket Forums! This site was created in 2006, to provide enthusiasts with a place to discuss T-Buckets. Over the years, there have been many imitators, but this is the T-Bucket resource you have been looking to find. We encourage you to register a FREE account and join in on the discussions.