New Member

[davefalconer]

I am brand new to this site. I traded my drag car for a 100" wheelbase T-Bucket with a chevy big block. I am having the bench seat redone so I can sit lower in the car, and am trying to figure out how to raise the front windshield. The car has a roll bar, and I'm thinking about adding head rests attached to the roll bar on each side. I would like to have the motor operate at 180 degrees and am wondering if two smaller electric fans rather than the one large fan now in place, would do a better job of keeping the temperature at the 180 degree mark

 

[Duke]

You will have to determine what the CFM is for both configurations. I would bet you are better off with one large fan.

 

[RPM]

I run 2 smaller fans rather than 1 big one and it works great. They do pull a lot of amps though.

 

[mikesplumbing]

Welcome from Wisconsin Dave!!!

Mike

 

[chopfather]

welcome from central oregon dave

 

[VegasBruce]

Welcome :shrug:

 

[Telman2]

Welcome to the forum Dave, there's thread titled engine heat that you may find interesting.

 

[eafree]

Welcome to the forum frm north Texas.

Eric