Off Center Rear End

[dick stave]

I am using a rear end out of a '91 S-10 pickup for my project. The center of the pinion/yoke is 1 1/8" to the passenger side. Is it best to center the yoke and allow the wheels to be offset 1 1/8" to the right side of the car to ensure there is no drive shaft vibrations? I suppose I could use a wheel spacer to get things close.I appreciate your input.

Thanks, jeff.

 

[2old2fast]

absolutely not! center the housing, run the driveshaft offset.

dave

 

[dick stave]

Thanks very much. You guys are very helpful. Jeff.

 

[bobby6319]

I am using a rear end out of a '91 S-10 pickup for my project. The center of the pinion/yoke is 1 1/8" to the passenger side. Is it best to center the yoke and allow the wheels to be offset 1 1/8" to the right side of the car to ensure there is no drive shaft vibrations? I suppose I could use a wheel spacer to get things close.I appreciate your input.

Thanks, jeff.

I have a ford 9 inch and they are off set my drive shaft runs at an angle to the drivers side and no vibes