I am having a hard time coming up with an idea for the lower link attachment point brackets. The problem is that the center of the rod end will be around 2-1/2" below and 4" out from the frame rail. The body will be channeled completely over the frame, with a gap of about 1" between the frame and the flange on the bottom of the body. If possible I'd prefer a double shear arrangement. Also, if possible I'd prefer a bolt-on solution.
So far, all of my ideas have shared 2 things...a 3/8" plate fastened to the side of the frame, and extending below the frame and body...and all have been exceedingly ugly.
Any ideas and pics will be greatly appreciated.
So far, all of my ideas have shared 2 things...a 3/8" plate fastened to the side of the frame, and extending below the frame and body...and all have been exceedingly ugly.
Any ideas and pics will be greatly appreciated.