Hey guys, I have been doing some searching and mocking up trying to figure this out but need some help. So far I have built my frame and tacked up the rear spring and radius components to the rear axle. I am now thinking the rear rods may not clear the floor of the body. The bat wings are 3 inches from the frame but since the kick up is about 14 inches ( going for a low stance) the radius rods are sitting a little above the frame towards the back.
Should I look at relocating the batwings towards the outside more? Or maybe think about mounting them inside the frame? The frame is 27 7/8 s wide in the rear. Thanks!
Should I look at relocating the batwings towards the outside more? Or maybe think about mounting them inside the frame? The frame is 27 7/8 s wide in the rear. Thanks!