choppinczech
Well-Known Member
I'm getting my transmission tunnel made and glassed in. Here's some pics of the process.
1 inch foam and duct tape.
Resin soaked fleece to even out the bumps. Adds another 1/8".
Body filler.
High build primer then waxed the plug.
4 coats of PVA.
Gel coat.
1/4" of fiberglass mat.
Glassing in around the floor and drive shaft tunnel.
Pulled up and off of the plug.
I'll finish glassing inside the firewall area by tipping the the body on it's nose.
1 inch foam and duct tape.
Resin soaked fleece to even out the bumps. Adds another 1/8".
Body filler.
High build primer then waxed the plug.
4 coats of PVA.
Gel coat.
1/4" of fiberglass mat.
Glassing in around the floor and drive shaft tunnel.
Pulled up and off of the plug.
I'll finish glassing inside the firewall area by tipping the the body on it's nose.