My ProjecTee

[Spanky]

Spooky! Just in time for Halloween!

 

[DonnyRay]

nice photo spanky. Thanks , i love it !! I am currently modifying my doors to fit the body. I had to do alot of cutting to weaken the door's resistence. Now i'm glassing everything back together. I'll try to get some photos.

 

[DonnyRay]

Here's some photos i promised y'all :

 

[DonnyRay]

more photos:

 

[DonnyRay]

more photos: Hope y'all like these pix.

 

[Spanky]

Looks like a lot of work! Keeping the theme going . . . creepy!

 

[RodStRace]

Saw you post in the seat thread.
Needs this fabric.

Little Johnny Halloween 3D Skulls Natural Cotton Fabric by 1/4 Metre*

Designer : Little Johnny Range : Halloween 3D Description : 3D Skulls Colour : Natural Width : Approx 59"" (150cms) 100% Cotton Available by the 1/4 Metre (Fat Quarter) Multiple orders will be sent as a continuous piece 1 Fat Quarter = 19" x 59" (50 x 150cm) 2 Fat Quarters/1/2 Metre = 19" x...

fabricshack.co.uk

 

[DonnyRay]

Thanks RodStRace. THIS PHOTO MADE MY JAW DROP : I'm planning to purchase several yards. WOW !!!

 

[DonnyRay]

Attention ; RodStRace , i just ordered 5 yds from fabricshack.com.uk . Thanks again for your great idea.

 

[RodStRace]

You gotta embrace it if that's the theme!
I just hope the actual product makes you happy.

This pic makes it look like it is printed to look 3D not actual bumps.

 

[DonnyRay]

I've been working on my tranny tunnel (doghouse). It's coming along pretty good. I removed the spider's head & replaced it with a skull.

 

[DonnyRay]

I plan to install windshield wipers under the cowl area. I plan to use a 1972 VW beetle wiper assembly. I've ordered the parts from Ebay , just waiting for deliveries. The wiper assembly is supposed to arrive on Monday 4-13-2026. I recently purchased a seat ( back seat from a jeep wrangler) this is my 3rd attempt at finding a seat to fit. I'm also working toward a running engine ( it's about time ). I also converted my fuel system from a carbureted system to fuel injection. I'm using a Fitech set up. I dumped the bearclaw system on my doors & i'm returning to an earlier setup. ( 32 ford door latch assembly ). I hung on to my inner door handles which fits the exterior door handles ). I located a pair of striker plates from Speedway Motors ). Time to FABRICATE.

 

[RodStRace]

Tim over at the HAMB incorporated wipers on his T.
I can't say I've seen any others with them in the cowl. It took a lot of planning and fab to get them in and working. He also included a heater and defrost, which upped the complication factor by 100!
This link drops you into page 33 of his build, where the wipers start. I would consider his build top notch so you may want to read through the whole thing.

Hot Rods - The Belly Button Bucket Build Thread

Somewhat like the ~'64 Tbird rear seat? On the htr-valves: There are true no-bypass valves anymore, at least that I know of. All I've seen for the last...

www.jalopyjournal.com