Welding table

[Todd]

This welding table was built almost entirely from the scrap yard. It has adjustable feet made from new 3/4" NF nuts and bolts, the only new items on it. I had some plugs left over from drilling 2 inch holes in 1/4" plate, sanded them up smooth and welded them to the bolt head. In retrospect, I should have used the 3" plugs. The center top pops out if needed and has different holes that help with clamping.

 

[Baby Huey]

I like it, I think it looks real good. I like the long arms on the sides to clamp to, good thinkin ! Good Job !

I have a side plate off of a Drum from an old Steam Donkey, It's got lots of big holes in it that come in handy to clamp to...... I bolted an old vice to it, helps hold small pieces.... "BH"

 

[jmr122848]

you have a better scrap yard than I do! and more skill and imagination.
Mike in ep

 

[Todd]

you have a better scrap yard than I do! and more skill and imagination.
Mike in ep

Youngster was one of my influences early on. But I still have a ways to go.