Chevy Front Spindles

[Mr. Fixit]

Hi Everyone,

Can you tell me it there if these front spindles are handed (left and right)? I am putting them back on the axle and see from my prior photos that the zerk fittings on the passenger side were facing front and on the drivers side were facing rear. Visually they both look the same so I am wondering if I can flip one over so that both sides have the zerks facint to the rear. Please advise.

Thanks as always...

 

[RPM]

Hi Everyone,

Can you tell me it there if these front spindles are handed (left and right)? I am putting them back on the axle and see from my prior photos that the zerk fittings on the passenger side were facing front and on the drivers side were facing rear. Visually they both look the same so I am wondering if I can flip one over so that both sides have the zerks facint to the rear. Please advise.

Thanks as always...

Both spindles are the same, there is no left or right. So yes on one side the zerks face forward and on the other they face back.

 

[Mr. Fixit]

Both spindles are the same, there is no left or right. So yes on one side the zerks face forward and on the other they face back.

Thanks Ron.

 

[bobby6319]

Hi Everyone,

Can you tell me it there if these front spindles are handed (left and right)? I am putting them back on the axle and see from my prior photos that the zerk fittings on the passenger side were facing front and on the drivers side were facing rear. Visually they both look the same so I am wondering if I can flip one over so that both sides have the zerks facint to the rear. Please advise.

Thanks as always...

no you can not turn it upside down they have camber built in them

 

[TDitty]

good point Bobby I found that out after putting chev spindles on.

no you can not turn it upside down they have camber built in them